Davidsonville, MD Air Conditioning, Heating and Plumbing Services
Supreme Air provides Air Conditioning, Heating and Plumbing Services, Repair, Installation, Maintenance, and Tune Up in Davidsonville, MD and surrounding areas.
Check out what some of our customers are saying about Supreme Air.
for Davidsonville, MD
Kafayat - Davidsonville, MD
Response from Supreme Service Today:
Thank you so much for the outstanding review! We're so glad to have provided such outstanding service during our visit. We're hoping to continue this in the future for all of your HVAC & Plumbing needs. Have a supreme day!
Checked dip switches and reset unit to try to bring fan speed up. Checked refrigerate pressures and found to be good. Customer says the air flow is better but not like it was. Customer would like someone to come out to give them a price on a replacement unit.
On arrival found 2nd flr outdoor unit not operating ,found disconnect was at off position.corrected the position to on .unit came on normal .also customer and I spoke about hard start kits and the benefits of having them installed .i installed two hardstart kits .units operating normal
Reschedule the spring pm b/c the customer she didnâ€™t have air filters she needs to be changed.
I went into the attic and basement with the vacuum cleaner and cleaned the drain lines. I used a brush inside the traps and flushed with water to push any debris down the drain line. Both drains are free from obstruction and both have safety devices installed. I checked the filters and they are clean. Coils and blower wheels are clean. I checked the electrical wiring and electrical systems, all are within specification. Both units are cooling with normal delta temperatures. Units are operating normal. I recommended installing hard start kits to each unit outdoors. These devices take the strain at start up off the compressor and greatly help to prevent compressor failure due to shorted out internal windings. Customer will talk to there husband about adding these.
On arrival found system not operating,found gas pressure not set correctly.adjusted gas pressures ,also configured furnace To bring the fan on when heat pump is running .system operating normal
Furnace would fire up when it had set for a while but would not fire back up when it was hot. I checked the pressure being pulled by the inducer and it was under 1.25 unless the furnace had time to cool off. I went through every procedure to rule out causes of low draft pressure, including checking drain tubes to the collector box and the collector box itself. I cut the exhaust pipe to see if the pressure increased and removed the burner compartment door but the draft pressure hardly increased. This lead me to pull as much off to inspect the heat exchanger. Using a scoping camera I was able to go around a bend to find the cause, a cracked heat exchanger in the area with severe discoloration due to overheating. I was able to show the customer the crack. I made the furnace inoperable and turned the gas off. A sales person is coming out tomorrow to quote replacement. Customer does not want this to happen with a new furnace.